Sailor's Solutions LLC      
 
product<br>image
Click to Enlarge

WP026 16-14 Ga. Ring #10 Stud, Waterproof (pack of 12) Made in USA
Waterproof triple layer technology forms the best watertight seal!
$9.95

View Cart

Problem:
It's an undisputed fact that most electrical problems on boats are traceable to failed connections. Most heat shrink connectors use a stiff and relatively short nylon insulating jacket with internal adhesive. Nylon jackets are difficult to heat-shrink and burning your wire jacket is a common occurrence. An extra heat shrink tube on the outside usually helps but often times makes for a sloppy looking job that defies inspection.

Solution:
Now it's easy to get secure professional-looking results with these amazing waterproof wire crimp connectors! Our waterproof connectors are far superior to typical after-market crimp connectors available. These connectors crimp down strongly and have a nylon protective jacket covered by a soft long polyolefin shrink jacket with lots of internal waterproof adhesive. This crimp gives your wire a strong strain relief and a waterproof seal. Once you work with our connectors you won't be satisfied with any others. We guarantee it!

Features:

  • A triple layer of protection around a 99.9% copper tinned connector provides the industry's most rugged and environmentally secure design.
  • Color-coded nylon insulation provides excellent puncture resistance.
  • Adhesive lining blocks out water and adds superior tensile strength and strain relief, while the outer layer of extra long clear polyolefin shrinks down around the wire sheathing to allow a complete environmental and abrasion resistant seal.
  • Seamless 99.9% copper tube for maximum strength and conductivity.
  • Three protective insulating layers.
  • Nylon inner layer adds mechanical strength and impact resistance.
  • Aggressive proprietary adhesive seals out moisture and provides strain relief.
  • Outer layer of clear extra long polyolefin shrinks easily without burning your wire jacket excellent abrasion resistance while allowing high visibility for inspection of the connection.
  • Nylon layer is see-through and color-coded to insure proper installation.

All connector sizes are bulk packed in 12 packs to save you money. Truly a superior product at a breakthrough introductory price!

* Meets or exceeds all UL and CSA requirements

product<br>image
SCAD MLC™ Masthead Light Controller
Turns ordinary anchor light into distress signal providing an important safety feature.
$99.00
product<br>image
Hooknife with 29 to 46 inch adjustable handle.
Clears lines fast!
$86.00
product<br>image
Small Soundproofing Kit - 12 tiles typical 28' boat engine compartment (1 inch X 1 foot X 1 foot tiles)
New and improved with fiberglass reinforced reflective surface!
You're going to love the quiet motoring!
$124.52
product<br>image
Laser Rescue Flare
Hand-held day and nighttime laser signaling device.
$99.95
product<br>image
SCAD TM2 Tank Monitor for Two Tanks (sensors sold separately)
Monitor two tanks with the touch of a button.
$135.00
product<br>image
SCAD Sensibulb™ LED Light - LED cabin light bulb replacement Made in USA!
Jan '09 Practical Sailor's Highest Lumen Output!The Brightest output LED system, pleasing color, broad focus, very low battery draw. Fits into vertical and horizontal fixtures! Zero radio interference!
$24.95
product<br>image
Lifeline AGM Deep Cycle Marine Battery
12 Volt (Size)24 (Capacity)80 Amp Hr

Charges deeper, faster and without maintenance!
Will not spill or leak!
$279.95
product<br>image
Medium Soundproofing Kit- 18 tiles typical 32'-36' boat engine compartment (1 inch X 1 foot X 1 foot tiles)
New and improved with fiberglass reinforced reflective surface!
You're going to love the quiet motoring!
$178.27

Go to top of page.