Sailor's Solutions LLC      
 
product<br>image
Click to Enlarge

WP016 12-10 Ga. Ring 3/8" Stud, Waterproof (pack of 12) Made in USA
Waterproof triple layer technology forms the best watertight seal!
$10.95

View Cart

Problem:
It's an undisputed fact that most electrical problems on boats are traceable to failed connections. Most heat shrink connectors use a stiff and relatively short nylon insulating jacket with internal adhesive. Nylon jackets are difficult to heat-shrink and burning your wire jacket is a common occurrence. An extra heat shrink tube on the outside usually helps but often times makes for a sloppy looking job that defies inspection.

Solution:
Now it's easy to get secure professional-looking results with these amazing waterproof wire crimp connectors! Our waterproof connectors are far superior to typical after-market crimp connectors available. These connectors crimp down strongly and have a nylon protective jacket covered by a soft long polyolefin shrink jacket with lots of internal waterproof adhesive. This crimp gives your wire a strong strain relief and a waterproof seal. Once you work with our connectors you won't be satisfied with any others. We guarantee it!

Features:

  • A triple layer of protection around a 99.9% copper tinned connector provides the industry's most rugged and environmentally secure design.
  • Color-coded nylon insulation provides excellent puncture resistance.
  • Adhesive lining blocks out water and adds superior tensile strength and strain relief, while the outer layer of extra long clear polyolefin shrinks down around the wire sheathing to allow a complete environmental and abrasion resistant seal.
  • Seamless 99.9% copper tube for maximum strength and conductivity.
  • Three protective insulating layers.
  • Nylon inner layer adds mechanical strength and impact resistance.
  • Aggressive proprietary adhesive seals out moisture and provides strain relief.
  • Outer layer of clear extra long polyolefin shrinks easily without burning your wire jacket excellent abrasion resistance while allowing high visibility for inspection of the connection.
  • Nylon layer is see-through and color-coded to insure proper installation.

All connector sizes are bulk packed in 12 packs to save you money. Truly a superior product at a breakthrough introductory price!

* Meets or exceeds all UL and CSA requirements

product<br>image
SCAD MLC™ Masthead Light Controller
Turns ordinary anchor light into distress signal providing an important safety feature.
$99.00
product<br>image
Coolnet Sailboat Hammock - Unique 3-point design sets up fast and stores easily
If you want a really nice place to lounge or sit you need this hammock! that you can rig in a few minutes
$169.99
product<br>image
Signal Mate 2NM LED Tri-Color plus Anchor, Wind Indicator Illumination and Daylight Sensor (bracket included)
Compact and rugged Designed for many years of operation. Daylight sensor turns Anchor light on/off Made in USA!
$310.00
product<br>image
Soundproofing Tile - 1 single tile (1 inch X 1 foot X 1 foot tile)
New and improved with fiberglass reinforced reflective surface!
You're going to love the quiet motoring!
$10.45
product<br>image
3M™ Scotchlite™ SOLAS Reflective Tape 2 inch wide- SOLD BY THE FOOT
See and be seen! Sold by the foot
$1.79
product<br>image
60-100-SR-IG alternator, ARS-5-H regulator, MC-TS-A Alternator Temp Sensor, MC-TS-B Battery Temp Sensor
Everything you need to upgrade your Yanmar,Perkins or other saddle mount dual foot alternators to the most efficient charging system for AGM or flooded cell batteries

Charge faster Charge better!
$939.95
product<br>image
Lifeline AGM Deep Cycle Marine Battery
12 Volt (Size)24 (Capacity)80 Amp Hr

Charges deeper, faster and without maintenance!
Will not spill or leak!
$279.95
product<br>image
Laser Rescue Flare
Hand-held day and nighttime laser signaling device.
$99.95

Go to top of page.